Sintering Effect on Cutting Tool Material

Authors

Keywords:

Powder metallurgy, marble cutting tool, sintering, synthetic diamond.

Abstract

Bronze-based Co-Ni-Sn alloy cutting tools used in natural stone cutting processes in our country are produced by powder metallurgy method. By selecting four different sintering temperatures in the production, the effect of the sintering temperature on the surface properties of the marble cutting tools was investigated. Synthetic diamond particles have been incorporated into the metal dust at certain ratios to provide stone cutting properties to the samples. Using the hot pressing technique as a method, the sintering temperature is; 600 ºC, 650 ºC, 700 ºC and 750 ºC were selected. The sintering pressure was 30 MPa, the sintering time was 3 minutes and the treatments were carried out in an argon gas atmosphere. Microstructure images of specimens with different sintering temperatures were produced.

Author Biography

Erdi Buluş, Material Technologies Specialist

Dear Editor,
We would like to present our nanotechnological filter work we have developed against the COVID-19 pandemic, which is the current problem of today.
We would like to present our nanofiber filter to our readers and the scientific community against the COVID-19 pandemic, which is a current issue of our membranes with structural, morphological, mechanical and filtration efficiency.
Best regards

Downloads

Published

2020-09-23

How to Cite

(1)
Buluş, E.; Sakarya Buluş, G.; Çelik, H. .; Somunkıran, İlyas .; Çelik, E. Sintering Effect on Cutting Tool Material. J. mater. electron. device. 2020, 5, 1-5.

Issue

Vol. 5 No. 1 (2020)

Section

Articles

Most read articles by the same author(s)

1 2 > >>